Challenger MT445
| 2002 - 2004 |
MT400 Series | Utility tractor |
|
Series map:
MT425
MT445
MT455
61.1hp*
72.2hp*
83.3hp*
*Estimated engine power for comparison only.
Production |
Manufacturer | Challenger (a part of AGCO)
|
Utility tractor |
Built in England |
The Challenger MT445 is similar to the Massey Ferguson 4233 and 4335. |
Mechanical |
Two- or four-wheel drive |
Power steering |
Hydraulic wet disc brakes |
Two-post folding ROPS. Cab available with air-conditioning. |
Hydraulics |
Type | open center
|
Pressure | 3046 psi 210.0 bar
|
Valves | 2 to 4
|
SCV flow | 10 gpm 37.9 lpm
|
Total flow | 25 gpm 94.6 lpm
|
Tractor hitch |
Rear Type | II
|
Control | electronic draft control
|
Rear lift (at 24"/610mm) | 4100 lbs 1859 kg
|
  | 6200 lbsOptOptional 2812 kg
|
Power Take-off (PTO) |
Rear PTO | independent
|
Rear PTO Type | 540/1000
|
Electrical |
Ground | negative
|
Charging system | alternator
|
Battery volts | 12
|
References |
|
MT400 - Serious Machinery to take on any challenge published in 2002, by AGCO |
Page information |
|
Copyright 2024 TractorData.com® |
TractorData is a family-owned small business located in Minnesota that has been providing reference information on tractors since 1999. |
Peter Easterlund - owner/author |
Email: Peter@TractorData.com |
Updated on July 14, 2023 |
©2000-2024 - TractorData.com®. Notice: Every attempt is made to ensure the data listed
is accurate. However, differences between sources, incomplete listings,
errors, and data entry mistakes do occur.
Consult official
literature from the manufacturer before attempting any service or repair.